I have been running 100hp shots for awhile via a NX wet kit and the motor has 205k miles on it. The plan as of now is just a decent "weekend" car that will go through a bottle maybe every other month or so. I'm now looking for a cam, and LT's. I'm trying to do a relatively "thrify build" so I would rather not have to do the bottom if it's not absolutely neccesary.

Is a 100 shot feasible with the motor staying together? What about 150?

 

With 200k on it, id say you will blow it up very quickly, and putting a cam in it, your asking for a spun bearing with them miles.

 

cam will most likely kill the bearings....as for n20 make sure you have good fuel system, and pull timing and youll be fine!!!
wouldent hurt to do a compression test first...

 

Both a cam and nitrous is pushing it in my opinion. If you do go forth with it, I would keep a rebuild in mind and start planning for it.

 

Thanks everyone. I guess I know what I need to do.

 

two words from a fellow juicer...

HELLZ NO!!!!!!!!!!

 

 

Just leave well enough alone. Or you'll be .

 

Pill it till ya kill it, then rebuild and choose the cam you wish.