Wanted: LT1 longtubes and gasket kit
07-03-2003, 12:41 AM
#1
Registered User
Thread Starter
Join Date: Jan 2001
Location: Sterling Heights, Michigan
Posts: 273
Wanted: LT1 longtubes and gasket kit
Looking for longtube headers for an LT1, coated/non coated, preferably 1 7/8 step.
And a gasket kit for LT1.
so lemmie hear whatcha got.
thanks
And a gasket kit for LT1.
so lemmie hear whatcha got.
thanks
07-03-2003, 06:52 AM
#2
Registered User
Join Date: Oct 1999
Location: Battle Creek, MI
Posts: 3,532
I have a set of brand new Jet Hot Long Tubes, non-emissions, a set of hooker 3" to 3" collectors, a pair of dynomax 3" x 16" bullets, and a full set of Breslin s/s locking bolts. Every bit of it is new. I'd take $550 for everything. To replace it all would cost you over $150 more than that...
07-04-2003, 08:38 PM
#4
Banned
Join Date: Aug 2001
Location: looking for a flow bench so Brook and I can race
Posts: 3,505
not to compete with my short bald friend over there,
but I just took out my dynatech long tubes with collectors and Y pipe.
$625 and its yours with Felpro header gaskets
These are coated inside and out and in decent shape.
They are damn expensive headers and the collectors are $100 a pop
They are really nice because you dont need to jack the motor up to get them in and they dont limit ground clearance at all.
I dont give a rats *** about ground clearance any more. Drag strip isn't all that bumpy
but I just took out my dynatech long tubes with collectors and Y pipe.
$625 and its yours with Felpro header gaskets
These are coated inside and out and in decent shape.
They are damn expensive headers and the collectors are $100 a pop
They are really nice because you dont need to jack the motor up to get them in and they dont limit ground clearance at all.I dont give a rats *** about ground clearance any more. Drag strip isn't all that bumpy
Thread
Thread Starter
Forum
Replies
Last Post
dbusch22
Forced Induction
6
10-31-2016 11:09 AM