Hey Guys,

Well i am selling off everything, i have all the right parts here to make a 600-1000hp car all hi-end parts SO PLEASE NO LOW BALLERS

This is off my 95 T/A

Vortech Ysi Z8's brackets , with my custom 4" suck side and air filter
cog pulleys 36mm, 78 teeth crank/30 blower
8 rib pulleys 8" crank pulley with spacers/ 2.65 blower pulley with belt
FMIC and all the piping with extra clamps and hose
vortech mondo BOV

$4000.00

Alky control kit
singal kit & dual kit as well, with an extra pump $500

Vic Jr intake with fuel rails $400
Nitrous Outlet elbow $300
http://www.ls1tech.com/forums/showth...=782110&page=3

matching AFR heads
These are Z8's old AFR heads(220) that were ported by GTP that flow 330cfm@.600 and mating Vic intake you will not find another set of heads like this with shaft mounts 1.7r $3500.00

84lbs def inj $350

Lonnie's twin intake fuel pump set up with Racetronic wiring kit $550

upper/lower A arms BMR/Sphon $500 (new)
K-Frame $250
Qa1 shacks with front springs front & rear $600 (new)
adj rear control arms $100
sphoon TQ arm $500
sphoon SFC CM $250 (new)

short block 355.....blower set up
eagle rods 4340
eagle 4340
Je blower pistions
4 bolt mail
balanced
ATi extra keyed crank
e-water
custom Bret B blower cam
Morrel's lifters (new)--------------$3000

Accel Dfi with fast track wiring, WBO2 with extra pcm/dataloger , dual synic dizzy, pro-key $1200

9" from DLS
35 spline axles
detroit locker

drive shaft for M6 tranny to match up with the 9" to handle 1000hp $3000.00

1 3/4 jethot LT header with Y-pipe $500
2 magnaflow cats new $200
borla cat back with adj plate $500

IF DOING PAYPAL ADD 3%

obo

 

i will take the rear adj control arms whats ur paypal ? can u send me a pic and what brand are they ?or a part num ? thx

 

Hey there ,, was wondering if you were gunna send me some pics? got the money waiting for ya !