it's alive!!!
#1
it's alive!!!
just wanted to take a moment to say i will be starting my new motor today at about 2:00 pm, so if your cruzin gratiot and getting board then stop on by and say hi.
the beast ride again,, commin to a drag strip near you.
the beast ride again,, commin to a drag strip near you.
#7
Scott heres the recipe for home brewed race fuel we were talking about:
http://www.f150online.com/forums/sho...Marvel+Mystery
http://www.f150online.com/forums/sho...Marvel+Mystery
#8
my neighbors are pissed!!!
well after sorting out the electrical gremlins, it started right up with about 50 deg. of timming total and backed down to 34.
this thing really sounds like a prostock motor, crisp and very responsive. i should be able to go to the dyno sometime next week. i need to rewire the whole msd and maybe get all new gages, my factory ones are going apeshizdiddy.
1 thing that really sucks is when i need to change the oil i have to disassemble the driver side header kust to get it on and off , so i thing i might put a relocation kit on it. thats all for now i'm trying to get to norwalk for the mm event but i'm not going to rush to get it done. later scott k.
this thing really sounds like a prostock motor, crisp and very responsive. i should be able to go to the dyno sometime next week. i need to rewire the whole msd and maybe get all new gages, my factory ones are going apeshizdiddy.
1 thing that really sucks is when i need to change the oil i have to disassemble the driver side header kust to get it on and off , so i thing i might put a relocation kit on it. thats all for now i'm trying to get to norwalk for the mm event but i'm not going to rush to get it done. later scott k.
Thread
Thread Starter
Forum
Replies
Last Post
C4m4roJoe
General 1967-2002 F-Body Tech
6
07-19-2015 10:59 PM
Robert95z
LT1 Based Engine Tech
16
05-30-2003 06:00 AM