http://www.mattz28.com/Caminstall/CammedZ28.wmv

 

How do you like that cam? I've been running it for about 600miles, and I think I lost a lot of low end torque.

 

Haven't driven it yet. Still have to run it at 2k RPMs for 15 mins, then I can go drive it. I'll let you know.

I drove Javier97Z28's when he had the 224/230 and I loved it. Felt like my car with bolt-ons and a 100 shot.

 

You know i lost a ton of low end also i dunno if its because i dont have my tune yet been waiting a week hopefully it will clear it up i know i was getting 5,000 knock counts everytime i reved it up and was pulling 10+ degrees of timing out.It doesnt come alive till about 3,500 then pulls like a raped ape

 

Sounds nice, can't wait to hear some sound clips with some revs.

 

Maybe we can get some outdoor drive by videos today

 

Sounds good Matt. Post up when you get some new track times. Have you gotten to drive it yet? If so hows it feel.

 

Just drove it about 35 miles. Pulls hard as hell, and I wouldn't be able to tell if I lost low end anyways since I have a 3200 stall.

 

I have this cam and love it. I can't wait to get to the track and see how it performs.

 

Sounds nice i hope to get my cam in soon.

 

Why, roller cams require no breakin, hell breakin lube has been speculated to caused damage to some roller cam motors.

Flat tappets required a 20 minute above idle breakin, on a roller motor start it make sure everything is adjusted and not leaking, maybe shut down and change the oil then enjoy.

 

Snapped my stock torque arm, and I'm happy as **** about that because with the noises it was making, I thought my transmission was toast.

 

I think it needs to be louder

 

Most of the time you won't loose tq. You just gain so much hp at the top, it makes the bottom SEEM insignificant when comparing. Ive got way more tq now and my cam is alot bigger than the 224/230.

 

*phew* that makes perfect sense.. I'm glad you found it man.

Time to give BMR a call..... you would have needed it eventually anyways.