CamaroZ28.Com Message Board - Will I have PTVC Trouble with my Heads Decked .030 a .039 Gasket and this cam?

CamaroZ28.Com Message Board (https://www.camaroz28.com/forums/)

- LT1 Based Engine Tech (https://www.camaroz28.com/forums/lt1-based-engine-tech-9/)

- - Will I have PTVC Trouble with my Heads Decked .030 a .039 Gasket and this cam? (https://www.camaroz28.com/forums/lt1-based-engine-tech-9/will-i-have-ptvc-trouble-my-heads-decked-030-039-gasket-cam-161286/)

Will I have PTVC Trouble with my Heads Decked .030 a .039 Gasket and this cam?

I have just got my heads decked .030, I am running I havent decided yet either the GM .029 Gasket or the Felpro 1074 .039 Gasket. I also have 1.6 Rockers, am I going to run into Piston to Vavle Clearence?

CCA-224-236-14
Dur@.050 224-236 | Lift .503-.521 | LSA 114 | RPM Range 2000-6200

Quote:

I am running heads that were shaved 0.030" and the 0.029" Impala head gaskets on a stock bottom end. I have a more lift than you (230/236-112 0.544"/0.555" lift) and its not a problem. There are people here running more lift than me without a problem. If you are worried about it, then verify it with modeling clay. There are guides on how to do it. Basically you put a thin layer of modeling clay on top of the piston and turn the engine over to see what kind of interference you will have.

BRAD

Oh I know how to clay its just the lazyness factor:D Come on what do you think Cz28 is for:p