Who offers the best center bolt valve cover gaskets?
#4
Originally posted by onebad96T/A
anyone else have any comments
anyone else have any comments
A valve cover gasket is a valve cover gasket...
Last edited by treyZ28; 02-25-2003 at 07:51 PM.
#6
Just seems like the factory gaskets keep leaking not a lot just a couple of drips here and there and when i was pulling the tranny i seen the oil around the back of the valve cover gaskets and i was just wondering if they make a cork valve cover gasket with the steel in the middle like the old style gaskets for sbc and the bbc. Plus i have fabricated alum valve covers and the stock gaskets are a pia to keep them on the valve covers when installing them.
treyZ28
so there is guide lines on what to post now!
treyZ28
so there is guide lines on what to post now!
#7
Originally posted by onebad96T/A
Just seems like the factory gaskets keep leaking not a lot just a couple of drips here and there and when i was pulling the tranny i seen the oil around the back of the valve cover gaskets and i was just wondering if they make a cork valve cover gasket with the steel in the middle like the old style gaskets for sbc and the bbc. Plus i have fabricated alum valve covers and the stock gaskets are a pia to keep them on the valve covers when installing them.
treyZ28
so there is guide lines on what to post now!
Just seems like the factory gaskets keep leaking not a lot just a couple of drips here and there and when i was pulling the tranny i seen the oil around the back of the valve cover gaskets and i was just wondering if they make a cork valve cover gasket with the steel in the middle like the old style gaskets for sbc and the bbc. Plus i have fabricated alum valve covers and the stock gaskets are a pia to keep them on the valve covers when installing them.
treyZ28
so there is guide lines on what to post now!
make sure they are on right, they can pop out when you put them back on
Thread
Thread Starter
Forum
Replies
Last Post