I need to eliminate my EGR, vats,air ,and maybe do some tweeking while Im there. I need the cables first and editting next. I talked to a guy that said he can do it, but I cant find his email and I need a cable from another guy I cant remember.
I dont want the $90 AKMcables. I need something cheaper and I will solder onto my wires without a problem. Hell I did the motor swap using a stock Caprice wiring harness I think I can do this!

 

If you don't want to spend the money for a quality cable then just make your own. AKM has schematics on his website on how to make your own... or at least he used to

FWIW, I recommend just buying a known good cable from AKM.

 

last i knew Andrews cables were only $65 if you dont go with that molded connector. and as Brent said you can make your own cable. Andrew can sell you all the parts to make it for maybe $35 or $40 but its a lot of work IMO. there are 2 guys that i know of who make a cables that are flash worthy and one is Andrew at AKM cables.. the other guy i think basically works with him so all the parts and prices should be the same.

 

I just bought a cable from andrew for 65 yesterday. I am waiting to delivery. I am sad I will not have it before this saturday when I goto the SLP cust day in Orlando.....I need some tuning pretty bad.

 

Andrew who , what where? he got a website? Also who can do the editting?

 

akmcables.com

 

ok i know now that Andrew is akm but wasnt there somebody else that was doing a solder-on kit without the expensive GM connector?

 

www.wotelectronics.com

 

Has anyone else had good luck with these cables. for both reading AND writing the PCM? I am going to order one if the word is good.

 

anybody else know where to get the cables you solder on? I dont feel like buying the expensive GM adaptor

 

if you are looking for a cable for $10 it wont happen. if you invest in a poor quality cable you risk the chance of loosing a PCM and i can guarantee you that will cost more than the small money you are tryin to save.

 

no less than $90 or should I stop being a puss and get one?

 

you can get a cable for $65 from either of the sites listed.

 

ok i said screw it and ordered the $45 cable from WOTelectronics which is really from Steve Russ? SO I hope its on the way and I can turn my SES light off on my swap project

 

As for the editing, the best and the cheapest place is MadZ28.com. Ion, the owner, is a fellow board member, too (MadWolf). He made my tuning and I was simply amazed!! Ordered the program on Thursday, got the file next day! Contact him and tell him Victor sent you