True duals?? lt4 cam/stock heads..
True duals?? lt4 cam/stock heads..
Which exhaust should i get with my setup? I have a 355 LT1, with lt4 hotcam, 1.6rr, lt4 springs, cai, (tune on monday), Hooker LT's, 3" ORY, no egr/air/cats or any emission friendly things....and i think thats all that matters really?? I was thinking between true duals, flowmaster, magnaflow, borla, or corsa? Thats alot to choose from, but basically...im open to all ideas. Which will offer the most power/flow?
thanks in advance
thanks in advance
Re: True duals?? lt4 cam/stock heads..
Thats pretty much the same setup I'm running for now, I think true duals are complete over kill for what you and me have unless you just want to say you have them. I'm doing a stainless 3" single dumped before the rear axle with a borla muffler because $$ is short and I like the sound of the borla, I just tend to stay away from flowmasters but everyone has their own opinion...
Re: True duals?? lt4 cam/stock heads..
I have 2.5 ture dual four 18" bullet with X pipe two bullet under the car and two at the rear after axle. Not loud at a cruise but sound very good at WOT. Nice deep sound at idle and at WOT
dual 2.5" pipes flow about equal to a single 3.5" pipe...
assuming reasonably good mufflers...the duals will always outflow the catback setup.
it's hard to beat duals for sound.
but the corsa does sound good...but you also pay for it!!
in terms of flow...i think they'd rank like this:
duals, borla (assume the open plate), magnaflow, corsa, blowmaster
for budget with great flow and great sound and great quality...magnaflow.
assuming reasonably good mufflers...the duals will always outflow the catback setup.
it's hard to beat duals for sound.
but the corsa does sound good...but you also pay for it!!
in terms of flow...i think they'd rank like this:
duals, borla (assume the open plate), magnaflow, corsa, blowmaster
for budget with great flow and great sound and great quality...magnaflow.
Thread
Thread Starter
Forum
Replies
Last Post
RX Speed Works
Supporting Vendor Group Purchases and Sales
3
Oct 1, 2015 10:19 PM



