This sucks just got my junk running again after 4 years and now I can't drive it!
This sucks just got my junk running again after 4 years and now I can't drive it!
Like the title say I can't drive it because I had to have surgery on my right shoulder and the car is 6 speed (97 formula in case your wondring) The recovery so far is pretty sore I had the procedure yesterday. The repared my labrium, rotator tendon,and also tightend the capsul, GOOD TIMES! I got it out to test and tune at least Fri. ran it light didn't want to tear up the stock 10 bolt first time out and now I hope to be able to get the rear end together over the winter. The car is running pretty well I have a MadZ tune and I even managed to cut a 1.61 "60 ft. on a stock rear, 4:10 gear and a e.t drag with no carnage!
__________________
__________________
Glad to hear you got a chance to run her. I know the pain (and pain in the a$$) of shoulder surgery, I've had both of mine done. Not fun but well worth it. I can play ball now with my sons.
Hope your recovery goes well. I am sure you'll put aside some pain to put down some miles on the car
Hope your recovery goes well. I am sure you'll put aside some pain to put down some miles on the car
Nice 60's. Just don't screw up the shoulder by playing with the car, or I'll tell your doctor.
My right one is jacked too, but not that bad yet. Hopefully you can put a stronger rearend in the car soon. Let us know when you get a good pass in. Take care, Rick.
My right one is jacked too, but not that bad yet. Hopefully you can put a stronger rearend in the car soon. Let us know when you get a good pass in. Take care, Rick.
Thank for the kind words! So far this isn't as bad as my hernia surgery was I wok up from that with 12 staples! Over the winter I'll get all the suspesion and rear end taken care of along with pulling the intake to get a fogger kit plumbed.
Thread
Thread Starter
Forum
Replies
Last Post
supercharged94Z28
LT1 Based Engine Tech
12
Feb 24, 2003 10:22 PM
guionM
Automotive News / Industry / Future Vehicle Discussion
14
Jun 19, 2002 08:30 AM



