http://www.strokerkits.com/383_lt1_stroker_kits.htm

i am building up a motor for my car and have a good deal on this stroker kit. it will be in a high rpm setup. later on down the road i will be going FI..... do you think ni should get this kit or will it be a waste and ill be pulling it all apart down the road to build a totally forged setup?

 

Depending on the HP level you want.
If you want more than 500FWHP the cast crank is not the one.

 

Cnc-motorsports has better deals than that...

 

do you have a web site for cnc motorsports

 

www.cnc-motorsports.com

Hard to beat their prices when shipping is always 7.95 .

 

a Hi-RPM setup for a stroker maynot be a good idea. Normally you will see higher RPM Motors staying a 350 or a 355 with a big cam. I maybe total wrong but i only run my 383 to 6k and even then i still have bad thoughts in the back of my mind. maybe a few guys will chime in on this?

 

the guy doing my bottom end is the one that suggested it be a high rpm motor. he has built a few before. ive seen video and pictures of his motors at work. everyone in the plymouth area reccomends him for engine builds