RR's

Reply Subscribe

Thread Tools

Search this Thread

Dec 20, 2005 | 06:33 PM

hektyk

Thread Starter

Registered User

Joined: Jan 2001

Posts: 237

From: Cleburne, Texas

RR's

Do I need 3/8 or 7/16?? I found a good deal on some but I need to know what size to use/

Dec 20, 2005 | 06:51 PM

MyShibbyZ28

Registered User

Joined: Jul 2005

Posts: 1,783

Re: RR's

Stock is 3/8", and upgrade is 7/16".

Dec 20, 2005 | 06:52 PM

96flame

Registered User

Joined: Nov 2004

Posts: 599

From: Waterloo, Ontario

Re: RR's

Stock stud size is 3/8" if your going to do engine mods later and rev it high then 7/16" non self aligning would be the best option

Dec 20, 2005 | 06:56 PM

hektyk

Thread Starter

Registered User

Joined: Jan 2001

Posts: 237

From: Cleburne, Texas

Re: RR's

Cool thanks man. My friend has in his possesion a NIB Summit Alum Rr set 1.6 ratio. Told me he would sell them to me.

Last edited by hektyk; Dec 21, 2005 at 12:58 PM.

Dec 20, 2005 | 07:02 PM

96flame

Registered User

Joined: Nov 2004

Posts: 599

From: Waterloo, Ontario

Re: RR's

Verify the part # will fit an LT1. Sounds too cheap to me

Dec 21, 2005 | 07:25 AM

wrd1972

Registered User

Joined: Aug 2005

Posts: 4,405

From: Kantuckee Yo'

Re: RR's

I just did a RR's and LT4 springs install and I chose to go with the 7/16 studs. It was a few bucks more and cant hurt plus they will become valuable if in the future I port the heads and throw in a cam.

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last