Question on Hypertech termostat install.
#1
Question on Hypertech termostat install.
Do I need to drain any antifreeze prior to the install? If so, how much? Do I need to apply any sealant to the thermostat when reinstalling it?
Thanks,
Jeff
Thanks,
Jeff
#2
just de-pressurize the cooling system by taking the radiator cap off after the car has been sitting for a few hours, and you can take the thermostat housing off....make sure to have rags around it so no coolant drips onto the optispark. the gasket comes on the thermostat so just take the old one out and pop the new one in!
#4
Wow, those replies were fast. Thank you both for the useful information. Now I feel better about doing the install.
Thanks again,
Jeff
Thanks again,
Jeff
Last edited by Jeff - '97 Formula WS6; 07-11-2003 at 11:01 PM.
Thread
Thread Starter
Forum
Replies
Last Post
lbrowne
LT1 Based Engine Tech
25
11-13-2011 04:25 PM