Pushrod Length

Reply Subscribe

Thread Tools

Search this Thread

Aug 5, 2005 | 10:23 AM

93 4mula

Thread Starter

Registered User

Joined: Jan 2005

Posts: 585

From: Ocean Springs,MS

Pushrod Length

Before I buy one of those tools just curious if anyone could tell me. I had my heads milled .025 and the deck of my block had a little bit of surface rust nothing major and they just went over that and cleaned it up, anyone know which pushrod I should get? Also is that with the .029 or .039 head gasket?

Last edited by 93 4mula; Aug 5, 2005 at 05:02 PM.

Aug 5, 2005 | 11:33 AM

1racerdude

Banned

Joined: May 2003

Posts: 6,661

From: LA (lower Alabama)

Re: Pushrod Length

Quote:

Originally Posted by 93 4mula

Before I buy one of those tools just curious if anyone could tell me. I had my heads milled .25 and the deck of my block had a little bit of surface rust nothing major and they just went over that and cleaned it up, anyone know which pushrod I should get? Also is that with the .29 or .39 head gasket?

Is that .250 or .025 on the heads?

Aug 5, 2005 | 05:01 PM

93 4mula

Thread Starter

Registered User

Joined: Jan 2005

Posts: 585

From: Ocean Springs,MS

Re: Pushrod Length

.025 is 25 thousandths right? Sorry bout that..

Aug 5, 2005 | 06:06 PM

NVetro

Registered User

Joined: Jun 2003

Posts: 1,439

From: New Jersey

Re: Pushrod Length

You mite have to go with the 7.150" rods as opposed to the 7.200". But I would definitly get a push rod legnth checker to be 100% sure. Push rods are usally the last thing you buy