1996 Z28 M6, stock 3:42, Hardtop, 92K, new Delco O2's & fuel filter otherwise 100% stock, Mobil 1 Synthetic Blend, on stock salad shooters & General tires, with mods...

SLP CAI
Shock tower brace & subframes
SLP Clutch & Flywheel package
Hurst Short Stick
Flowmaster muffler

Considering adding to this combo the 1LE elbow and a manual cutout

Wondering what you guys think it'll pull on the dyno and 1/4 mile, with and without the cutout. Never done both yet with this car and doing so this spring so I'm quite curious. Car runs great and pulls very strong. Daily driver car so figure above average driver power shifting.

 

I'll take a swing and say 13.7-13.9 @ 104-106. Through exhaust. Either way, good luck with it.

 

i would guess about 13.9 at about 102.

 

Very cool, I was expecting high 13's, too.

Anyone else hazard a guess???

 

I'm not really sure what's going on with this reply. But I think he's trying to be a smart *** but coming across as just an ***. I'm not really sure. Smiley's and such tend to help when kidding around.

Anyway, I ran 13.8 bone stock with SLP 2OTL no CAI and a 158,000 mile engine on stock tires and rims. It all depends on the driver and car. My car for some reason likes the 1/4 mile. However my friends car with Magnaflow and K&N CAI ran a best of 14.2 with 95,000 miles. Both were 94's.

Mind you, this was when my car was stock. She's much faster now

 

93 Z with 60K, MSD 6-AL, 8.5 MM wires, Flowmaster muffler, and K&N CAI run 13.87 at 100 mph.

However, it did come factory with 3.23 gears