I am installing my MAC headers in a little over a week. While I am down there I want change the spark plugs and wires. I was looking at MSD 8.5mm wires. Are these the best to use or should I buy Talyor wires? Is there anything else I need beside the wires? I do not intend to run the wires over the valve covers unless I need to. Tahnks for the advice.

 

I'm not sure about MSD's, but Taylors will fit in the stock wire looms, so no "OVC" wires are needed, just run them in the stock location..... once again, not sure about MSD's... maybe so, maybe not...

I have MAC headers and it works fine w/ Taylor wires in the stock looms.

-Michael