I rebuilt my bottom end and slid in a new cam. Hopefully I can improve on my times a good bit. Alot of changes went on with the car along with the fresh motor. Cam is 263/272 Allan Futral designed Cam motion setup. Excuse the smoke, I hadn't hooked up my map yet so it was running kinda rich. This is at 1100 rpm idle and through hooker headers with bullet mufflers hung off the collectors with dumps. Also..excuse the mess in the garage..I'm building a new shop out back and had to clear out my old one..I got crap everywhere..lol.

http://formula95.ls2.com/Video/newsetup.wmv

 

I can feel my eyes watering right now . She sounds good man, I cant believe thats 1100rpm, sounds like 900rpm. Good luck with the new combo.

 

Holy crap Tim, that thing has got a little lope to it, eh? Sounds awesome.

 

Sounds awesome! Did you make any significant changes to the bottom end when you rebuilt it?

 

Dayuuuuuumm!!

 

mean...yeap..it would bring tears to your eyes..lol. Its all fixed now with the map hooked up.

Micheal... I was really suprised about how much more it had than my old cam considering thats its only slightly bigger at 50 deg. We all know there is more to a cam that @ 50 though..hehe. Allan and Terry at futral motorsports came up with this cam....we will see how much it helps me reach my goal

Grease, no changes to the bottom end. Same rods/pistons/crank as the old motor. Just reringed it and put new bearings/bolts/studs in it. Significant changes this round would be the cam change and put a single plane with top mount 4 bbl TB on it. I also made some changes to the car that should help it run just alittle better..hehe.

thanks everyone. I'm going to see if I can get a NA 6 speed pass. Will still be using gm heads(lt4), stock crank, 2 bolt block...we will see how it goes.

 

ahhhhhh, the smell and sounds of a bad azz 355 with a man cam

Sounds great! I'm going to try and do something similar with my exhaust.

 

holy christ, that thing sounds so mean... lol

 

If it runs like it sounds it may be pretty fast.hehe.

 

What's the powerband on that cam?

 

I should be shifting between 7400-7600

here is a dyno of the old motor

 

Cars like that at street lights make me take interest in my radio buttons so I dont catch an *** whooopin

 

I can't hear my radio...

 

Sounds good Tim!

 

everyone say hello to the guy who put the bottom end together..Jason99TA. I know your waiting for this thing to hit the track too jason.