Need a little input on new build
Thread Starter
Registered User
Joined: Nov 2002
Posts: 130
Need a little input on new build
ok so I have my new build almost complete.
I've got a set of le1 heads, a cc306, and I'm prolly gonna pick up/port my own intake to match the heads.
Right now I have 7cc flat top 4 relief pistons. They are .025 in the hole and I was planning on getting a .026 VR head gasket.
This puts DCR at 7.9 and SCR at 10.63.
Looking at what I had with my old setup. see sig. I had 8.2ish DCR.
How well is this motor gonna run. Should I consider upgrading to 5cc or less pistons to bump that up a little?
I've got a set of le1 heads, a cc306, and I'm prolly gonna pick up/port my own intake to match the heads.
Right now I have 7cc flat top 4 relief pistons. They are .025 in the hole and I was planning on getting a .026 VR head gasket.
This puts DCR at 7.9 and SCR at 10.63.
Looking at what I had with my old setup. see sig. I had 8.2ish DCR.
How well is this motor gonna run. Should I consider upgrading to 5cc or less pistons to bump that up a little?
Thread
Thread Starter
Forum
Replies
Last Post
Nayr
LT1 Based Engine Tech
7
Mar 3, 2023 08:34 PM