I just recently bought a MSD 6a box and blaster 2 coil. I know a lot of people use this setup on their f-body, just wondering where the best place to mount it would be. LT1s run very hot so i dont want to put it in a place where my box will heat up to high temperatures, any suggestions on where to mount it? Just seems really crowded inside the engine bay.

 

mount it on the driver side, right above the intake tube below where the fuel lines enter the engine bay

 

Back when I had one, I mounted it to one of the triangular plastic mud shields under the nose, in front. Right under where the cold air induction filter would be if that helps any.

Here's a picture.

 

Since I had previously removed my washer reservoir (sp?), I ended up mounting mine to the back of the bumper support in the nose. It's kinda a pain to get it mounted, but it's nice and dry and cool there. Can hardly see it with the hood open, and there are a couple nice looms to route wires in at the front.

Just another option

Dave C.

 

I put mine on the fender side of the CAI induction, pointing into the headlight housing. Had to remove that black plastic stuff in there.

http://atljar.com/637879-R1-22A.jpg