What kind of times would say a basically stock Lt1 6-speed or auto run 1/8? What about one with just some boltons? What about with a mild cam?

 

I'd say probably somewhere around the low 9's to high 8's. Mine ran a 8.6 in the 1/8th mile

 

ttt

 

with CAI and Catback I ran 9.0 @ 80mph w/2.19 60'

With more bolt-ons (full exhaust, 3.73's, etc...) I ran 8.69 @ 83.5mph w/2.14 60'.

Havent gotten a decent run with the cam and dr's yet. I would think 8.20's @ 87-88mph. I picked up 50rwhp from the cam and DIY heads, so I figure a good 4-5mph should be reasonable.

 

My best time is in my sig.....bolt-ons included shorties, flowmaster cat-back, 3.73's, CAI, IAT sensor, !Cat, !MAF, MAF ends, 160 stat with a 1.97 60 on street tires. Oh...AT as well

 

my best 1/8th is 8.6 @ 88mph

Thats with a CC306 on stock heads.
My best before cam was 8.7 @ 84

 

With a gear, headers (with cats), mild converter, K&N Filter, HPP+ and Nittos, I went 8.57 in the eighth.

 

Times in sig!! I can probably get another tenth or so off it!!


Brad

 

about a 9.0 is average, if a little better not by much, I went 9.1@78 with a high temp and clogged fuel filter, the car was stock, cutting some tires blazin, wheel standing, crowd pleasin 2.25 sixtys.

 

I went 9.0 @ 80.xx bone stock with a 2.0 60'. With just a crappy 12" SLP 2800 stall and cai I went 8.34 @ 81 with a 1.73 60'.

 

I ran a best of 7.7 at 93 mph on the "stock" botttom end.

 

I ran a best 8.91@80.45 mph with CAI and flowmaster muffler.

I don't have a good run since I added headers and cutout.

 

xxsaint69x-
Could you tell me a little more about this CC306 cam you have?

 

ttt

 

my best time with ported stock heads, hyd. roller and stock bottom end is 7.80 @ 90.xx