Well i think the z is blown. I was driving along and i pushed the clutch to shift as i was going around the cornner and the car stalled. I was like one block from my friends house so i started it again and drove to his house. When i got there it stalled again so i started it again and at 800 rpm the oil pressure was little to nil, at 2000 it was half. so im assuming i spun a bering or somthing. anyways i was wondering if anybody knew where a good place to buy stroker kits. i dont think i need fully forged as its only a 2 bolt and wont ever see more than 500hp

 

come on sombody must have a opinion on stroker kits. if this was about opti sparks or hotcams i would of allready had 50 responses sayin its bad, to small. lol

 

http://www.flatlanderracing.com/

LOOK! A site sponsor! imaginge that

 

How many miles were on your car?

 

130,000 km's (canada eh) ran exelent for 2 weeks after hotcam install now no workie. i should have the engine out tonight and see what exactly went wrong i assume i spun a rod bearing.