I have a "MISS" AFter engine is Gets Warm
I have a "MISS" AFter engine is Gets Warm
Hey Fbods.
OK I have MSD (OVC 8MM) wires on my LT1 355. NOw I before in the past I had to cut and splice a couple of my wires becuase it was missing bad. The passenger side wire towards the back was touching my Header (JET HOT LTs)
So I wrapped it up with eletrical tape just to band aide it. And it lasted only UNTIL last week. OK having said that the 90 Degree Boots are Burnt up on the Spark plug NUMBER 8 and 6 I think. SO I replaced the BOOT becuase I had extra in there. And at first it was running good. After it gets warm. Its starts to MISS. infact it back fired too. SO is this Plug WIRES?
CHris
OK I have MSD (OVC 8MM) wires on my LT1 355. NOw I before in the past I had to cut and splice a couple of my wires becuase it was missing bad. The passenger side wire towards the back was touching my Header (JET HOT LTs)
So I wrapped it up with eletrical tape just to band aide it. And it lasted only UNTIL last week. OK having said that the 90 Degree Boots are Burnt up on the Spark plug NUMBER 8 and 6 I think. SO I replaced the BOOT becuase I had extra in there. And at first it was running good. After it gets warm. Its starts to MISS. infact it back fired too. SO is this Plug WIRES?
CHris
Thread
Thread Starter
Forum
Replies
Last Post
Dan_the_ManZ28
LT1 Based Engine Tech
7
Feb 21, 2015 02:01 PM
jb4xx
General 1967-2002 F-Body Tech
9
Feb 2, 2015 10:00 PM
PFYC
Supporting Vendor Group Purchases and Sales
0
Jan 23, 2015 01:13 PM



