CamaroZ28.Com Message Board

LT1 Based Engine Tech 1993-1997 LT1/LT4 Engine Related

Header torque specs?

Thread Tools
 
Search this Thread
 
Old Nov 12, 2003 | 11:45 PM
Share
  #1  
Heatmaker's Avatar
Heatmaker
Thread Starter
Advanced Member
 
Joined: Nov 2003
Posts: 3,874
From: Under The Hood
Header torque specs?
I'm planning on instlaling my Headers tommorrow. Is there a torque specification for the Header bolts????
Reply
Old Nov 12, 2003 | 11:51 PM
Share
  #2  
Bud M's Avatar
Bud M
Registered User
 
Joined: Oct 2000
Posts: 2,915
From: Sacramento
If you are using Stage 8s just tighten them up with a short wrench and put on the clips, they will be fine.
Reply
Old Nov 12, 2003 | 11:54 PM
Share
  #3  
ShelbyZ28's Avatar
ShelbyZ28
Registered User
 
Joined: Jan 2001
Posts: 411
From: Lafayette, Indiana
It will be hard to get a torque wrench on them because its so tight. Just tighten them down the best you can and check them for about a week after to make sure they don't loosen.

Bryan
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Selling all my parts- built lt1 t56, full bmr, tons of LS stuff, QTP LS headers, etc
carguyshu
Parts For Sale
20
Jan 22, 2017 11:19 AM
Dyno run: Low Torque?
Russ95Z28
LT1 Based Engine Tech
4
Apr 23, 2015 01:55 PM
LT1 parts (small, aftermarket)
Jason Short
Parts For Sale
0
Jan 19, 2015 06:34 PM
Poor gas mileage...??
The Seer
Classic Engine Tech
2
Nov 26, 2014 05:55 PM
Back to Subforum
LT1 Based Engine Tech
View Next Unread
acceleration isn't good




Advanced Search

All times are GMT -5. The time now is 07:41 AM.