Getting ready to fire up my new stroker, but have ????
Thread Starter
Registered User
Joined: Jun 2002
Posts: 660
From: LakeLand, Florida
Getting ready to fire up my new stroker, but have ????
Before I start to bolt up all the stuff back onto the motor, I want to see and make sure the motor fires up.
What is the absolute mininum in terms of sensor hook ups that are needed for a quick 15 sec. fire up, anyone know?
Right now I have the opti harness, coil and control module, injectors, alt. wires, knock & coolant sensors I think thats it. But it will not start up. I do not have the o2 sensor hooked up and I didn't check for spark yet, it was getting cold out. I do know that I am getting fuel. What am I missing?
Thanks,
Scott
What is the absolute mininum in terms of sensor hook ups that are needed for a quick 15 sec. fire up, anyone know?
Right now I have the opti harness, coil and control module, injectors, alt. wires, knock & coolant sensors I think thats it. But it will not start up. I do not have the o2 sensor hooked up and I didn't check for spark yet, it was getting cold out. I do know that I am getting fuel. What am I missing?
Thanks,
Scott
Last edited by BlackDog; Dec 8, 2003 at 07:24 PM.
Thread
Thread Starter
Forum
Replies
Last Post
zFrank
New Member Introduction
3
Aug 12, 2015 03:46 AM