Finally made it to the dyno!
Thread Starter
Registered User
Joined: Sep 2003
Posts: 154
From: The Motor City
Finally made it to the dyno!
Well, I finally got a chance to put my car on the dyno. It was quite an interesting experience! A part of you is just kinda waiting for your car to break loose and go flying off of the dyno when it's going 120mph! Luckily all went well; no flying Trans Ams that day. 
Here's the sheet. Thought you all might like to take a look-see!
My only mods are Borla exhaust, TB bypass, and DMH Cutout. This run was with the cutout open, although the gain was only 1-2 hp.
Now I need some LT headers to take full advantage of the cutout!
Enjoy!
J
Oh yeah, the numbers ARE corrected.
Here's the sheet. Thought you all might like to take a look-see!
My only mods are Borla exhaust, TB bypass, and DMH Cutout. This run was with the cutout open, although the gain was only 1-2 hp.
Now I need some LT headers to take full advantage of the cutout!
Enjoy!
J
Oh yeah, the numbers ARE corrected.
Last edited by germ79; Jan 13, 2004 at 10:18 PM.
Registered User
Joined: Nov 2002
Posts: 252
From: Central IL
It is $75 for 3 pulls. Located at 100 W. Ash St.
Come check out the local board! www.fastrides.net
Come check out the local board! www.fastrides.net
Thread Starter
Registered User
Joined: Sep 2003
Posts: 154
From: The Motor City
Originally posted by BigBlueZ
It is $75 for 3 pulls. Located at 100 W. Ash St.
It is $75 for 3 pulls. Located at 100 W. Ash St.
They are nice there and make sure you get 3 good pulls.
I'll work on the link.
Thread
Thread Starter
Forum
Replies
Last Post
