does not idle after header install
does not idle after header install
I finally got the car started after I read that flooring the pedal while starting the car puts it in flood clear mode. Tons of smoke blew out of the exhaust and it ran pretty good I thought at all rpms up to 3k (didnt rev any higher than that) but it would not idle, it'd just quit. I'd have to floor the pedal to get if I started it again. Would this be a sign of fouled o2 sensors? I just swapped the plugs before I got it started so it's not those.
Thread
Thread Starter
Forum
Replies
Last Post
F(ast)-body
LT1 Based Engine Tech
8
Feb 26, 2003 09:05 AM



