does anyone have the instructions to do the ls1 lid conversion. also will any cowl hood fit?

 

I would assume take an LS1 radiator support/cover and lid and then a rubber intake hose that'll fit over the LT1 TB. Assuming it clears the hood of course.

 

Just do a search on that topic , I know that this has been brought up here pretty recently

 

Dont worry with it, it's not worth the trouble over a good CAI.

A dragstrip test was done over at LS1tech and gains were very minimal if any.


David

 

this is pretty much the general concensus on this, most people just do it to be different, personally i would just stick a good cai on there

 

well i have searched on here and ls1tech and i found no instructions. do you have to cut the lt1 rad support, and if you do where to cut it. also do you have to change to a ls1 rad support. the z was involved in a wreck and the rad support has to come out. whats involved other than getting the obvious things such as lower air box, intake ducting, lid, etc?