Here's a 4.10 gear from an Isuzu Rodeo (7.5" GM 10 bolt rear). There is a small chip on one ring gear tooth. Please see the image and let me know if you think this is OK to install. Found these cheap for a friend, but don't wanna wind up shooting ourselves in the foot trying to save a dollar, ya know?

 

i couldnt tell ya but nice camera

 

I've seen worse from my offroading days that were fine. I'd just make sure there was not rough burs but I think they look fine, I'm no gear expert though.

 

Yea, I"m like you Brett, I've pulled worse outta my buddy's lifted trucks and Jeeps, and were still pullin' hard. THe gear looks fine to me, but again, it's different when you're shopping for somone else and their money. Don't wanna screw the man over, ya know. But, sometimes (I know this) you just gotta buy on the budget and hope it works...always has for me, lol.