Code help please my car runs scary bad
Thread Starter
Registered User
Joined: Oct 2005
Posts: 58
Code 42 help please
So I got a cable and hooked my car up and without driving it with it just sitting the first time I pulled the codes I got. 13, 48, 41, 42, 77 so I was like 
. But now the only one it will pull after resetting them was 42.
Just tryiing to figure out what it means. By the way my car runs gret under normal driving conditions. Under WOT it pops and spits goes to redline at will scary stuff
.
. But now the only one it will pull after resetting them was 42.Just tryiing to figure out what it means. By the way my car runs gret under normal driving conditions. Under WOT it pops and spits goes to redline at will scary stuff
.
Last edited by slow_94z; Apr 15, 2007 at 11:44 PM.
Registered User
Joined: Jun 2005
Posts: 626
From: MN
13- Bank 1 (left) Heated Oxygen Sensor (HO2S) Circuit (open circuit)
48- Mass Air Flow (MAF) sensor circuit
41- Ignition Control (IC) circuit (open circuit)
42- Ignition Control (IC) circuit (shorted or grounded circuit)
28- Transmission Range (TR) pressure switch assembly fault
77- Cooling fan relay control circuit
28 could also have something to do with a fan relay or ac relay. Being that they went away and all you get now is the 42 I would not pay alot of attention to them and just concentrate on the 42. which being that the Ignition controller is grounded or shorted would probably be what is causeing your scaryness with the messed up firing.
48- Mass Air Flow (MAF) sensor circuit
41- Ignition Control (IC) circuit (open circuit)
42- Ignition Control (IC) circuit (shorted or grounded circuit)
28- Transmission Range (TR) pressure switch assembly fault
77- Cooling fan relay control circuit
28 could also have something to do with a fan relay or ac relay. Being that they went away and all you get now is the 42 I would not pay alot of attention to them and just concentrate on the 42. which being that the Ignition controller is grounded or shorted would probably be what is causeing your scaryness with the messed up firing.
Thread Starter
Registered User
Joined: Oct 2005
Posts: 58
Registered User
Joined: Jun 2005
Posts: 626
From: MN
not exactly sure where that is myself on an LT1. perhaps part of the Opti unit? I know on a standard distributor is is a part that is pluged into the distributor it's self inside the housing.. Might be something to ask in another post perhaps so people look at it.
Registered User
Joined: Aug 2004
Posts: 334
ignition control module. isn't that mounted with the coil on the driver side head.
but that code deals with either shorted or grounded, so i would assume its gonna be a wire issue, look at the wires coming off the icm and trace them out looking for a bare spot touching metal.
but that code deals with either shorted or grounded, so i would assume its gonna be a wire issue, look at the wires coming off the icm and trace them out looking for a bare spot touching metal.
Registered User
Joined: Jun 2005
Posts: 626
From: MN
being that that the ICM is a circuit board it is possible for it to ground or short internally. Best thing to do is to take it to a parts store that can test them for you. I know that most of them should be able to test and ICM. But it is possible for it its self to go bad as they have a tendancy to do after a while.
Thread
Thread Starter
Forum
Replies
Last Post
ro2207
LT1 Based Engine Tech
14
Dec 4, 2014 06:18 PM
PFYC
Supporting Vendor Group Purchases and Sales
0
Dec 1, 2014 08:08 AM
