heres what happen, I bought new MSD super conductors last summer and put them on. Sometime between now and then I burnt #5 real bad. I know this is a problems with headers so I'll ask if anyone else has done this or worse and bought a new set of wires and kept any of the non burnt wires. My reasoning is if someone has done what I did and bought new wires maybe they would be willing to sell me on of theirs. It's a long shot I realize but there has to be someone out there that has a set of burnt wires with a few good ones left. I just need #5 or any that are long enough for that matter. I have already checked out the other wires and was gonna just buy a new set but being that it is only the one wire and that they are pretty new I'll try my luck first. If you have any please let me know. thanks

 

#5 sucks...

Your gonna have to zip tie that bad boy away from the primary, Its tight under there but there is enough room to keep it away. I've burnt mine a few times....

It SUCKS !!!

 

I have 5 wires left from my first set. I lost 3 out of 4 on the passenger side. I put the stock ones back on until I learned to run them correctly. I burnt several stockers as well. I have since ordered a new set of MSD's and haven't burnt a one. What is the length your looking for and I will check to see if I have one. I think I do. It's probably longer if anything.

E-mail me at nealeugene@hotmail.com

 

Learned my lesson along time ago with burnt wires and headers. I run my MSD OTV, use wire tires to hold two wires in between the primaries and run the 1200* sleeves that I paid $70 bucks for at Thunderracing. Best $70 I ever spent.

 

ttt

 

ttt

 

^^^^^^^^^^^^^^^

 

t

 

you might get the response your looking for if you make a wanted to buy post in the wanted to buy section...

 

I burnt mine too I just bought a new set and used the 7 wire and then routed with the #7 plug wire. Its been 1yr and a half and no problems.