Was searching around just to see what I could find and would like to know what track times and horsepower/torque you should see with a setup like that? Searched it but could not find a whole lot. Thanks.
Rob

 

No one has any experience or insight with this setup??

 

there are too many variables on this setup to even "guess" at a track time.even with all variables it's hard to say what a car will actually time or the horsepower.compression ratio,rod length,flow on heads and intake,exhaust........

 

alright I will try and narrow it down a bit, rod length 6.0 forged bottom end, heads flow 275 @.600 intake/ 216 @.600 exhaust, vig 3200 or 2800 stall. Just trying to find a ballpark on this. The main reason I ask is just for future reference and doing a little data comparison. Thanks.
Rob