2.02/1.60 and a 5 angle job..
Thread Starter
Registered User
Joined: Mar 2003
Posts: 151
2.02/1.60 and a 5 angle job..
im thinking of getting a set of 2.02/1.60 manley race flo valves.
and getting a 5 angle valve job and milling a little. and putting new springs on a set of cores i have (94 lt1)
think it would be worth it??
iv searched and cant seem to find much on this setup..
tia....
and getting a 5 angle valve job and milling a little. and putting new springs on a set of cores i have (94 lt1)
think it would be worth it??
iv searched and cant seem to find much on this setup..
tia....
Registered User
Joined: Apr 2002
Posts: 552
From: San Antonio, Texas
IMO I would not go that big. I would stick with 2.00 and 1.56 Manley Race Flo Valves. The Crane 10308-1 Spring Retainer Kit is a good one to use. The springs are good up to .600 lift.
Are you going to port these heads in anyway? A full port or gasket matching? I dont see the need to get biger valves unless you are planning on running over 425 HP. The 1.94-1.50 would do just fine.
Are you going to port these heads in anyway? A full port or gasket matching? I dont see the need to get biger valves unless you are planning on running over 425 HP. The 1.94-1.50 would do just fine.
Thread
Thread Starter
Forum
Replies
Last Post
PFYC
Supporting Vendor Group Purchases and Sales
0
Aug 7, 2015 01:26 PM
