I have a 1994 TA

Stock Bottom end car
Dynatech 1 3/4 Cermic coated
4.10's with T/A Gridle
Aluminuim Drive shaft
Lt4 Hotcam Kit
150 Shot of JUICE
Turbo 350
B&M Stage two Shift Kit
Tci 3200 Stall
B&M supercooler
New opti
Msd wires, coil
BBK UNDERdrive pulley
Slp cold air
Pro-M Mass air
Cermic coated trick flow intake elbow
Arizonia Speed and Marine 54mm Throttle body
BFG Drag Radials

I know i am missing somethin but i can't remmeber.

Sorry to bore u bout the mod list, I have all these parts the majority is all been installed but in the progress of installing them.

Whats ur all opionon on my track times.

 

only a fun game if you actually have a track time..

 

Motor has about 85,000 Miles.


Still fun i just wanna see what u all predict.

Brake

 

way general question...only one way to find out

 

15.7 @202mph................in the 1/8th

 

11.60 @ 117mph. Just a guess...dont shoot the messenger

 

Damn, stole my guess.

 

do you know how to drive the car? what climate conditions? too many different things come into play. plus what exactly HAVE you installed out of that list?

 

I have everything on that list! I have my motor built justy need to put the radiattor in an a few little odds and ends.

I don't have the tranny in yet. Itas sitting in the floor beside the car. and i don't have the gears with the gridle in yet.

Between work and everything else it's hard to get time to fool with her. So i'm just buying everything and i'kll have her ready to go buy spring.

Brake

 

I Know how to drive my Car also! lol

I'm just hoping mid to low 11's and 12.50's all motor thats what i am praying for. Cutting 1.65's

Brake

 

I was going to say 11.5. Those radials are a must, without them, 12 flat if your lucky.

 

Two the top

 

I would say mid-11's with those BFG, but get some slicks it would be in the low-11's then.

 

I'd say 12.7ish on motor.

 

With 4.10 your gonna run out of gear around 120, depending on what rpm your gonna turn it.