im doin my brake pads today, and i took the 2 screws outa the back of the caliper (the 2x 12mm screws on the top and the bottom)

and my caliper wont come off or rotate back its like stuck to the rotor??

im lost, please help

 

You are talking about the screws that hold the whole caliper itself right? Sometimes you just have to rotate the rotor a bit while you pull the caliper away from it. Be careful though as it will dangle from the brake line if you let it go. If we are not on the same page, check this site out.

http://www.installuniversity.com

Look under install documents and brakes.

-Adam

 

thanks man, rotating the rotor while pullin is wut got it

 

No problem, I ran into the same problem with my brakes when I was doing it. Glad I could help.

-Adam