I want to install a transmission temperature guage on my 93 Z28, but I don't know how to do this. Where/how do I hook this up? Is there a good write up out there? I want this because I'd like to be able to keep an eye on the transmission if there is a problem I'd like to be able to react.

I was planning on using an A-pillar guage pod, and guage....
Thanks for all help.

 

Here you go, this is the guide I used...real easy..http://ken.lowrance.com/projects/TransCooler/

 

Does the sensor kit come with all the wire that will be needed(Wire that runs from A-Pillar to sensor on line...)?

Also how long to install?

 

You will need more wiring. Took me about an hour to do just the sensor.

 

Definately more wire. Pretty easy install. The sender plugs directly into the tranny, then run your wire. Plug and play!

 

Where at in the tranny? Can you take a picture and email me where your is plugged in at? Sorry I'm stupid

 

You're by no means stupid.
Anyway, I'll have that picture for you tomorrow.

 

Thanks!, the e-mail address is:
foraker-k-060@mail.mssc.edu


THANKS!

 

I would like to see a picture of that too. ripper95z@hotmail.com

 

Ditto, if its no problem

 

No problem, I'll just have to kidnap the digital from my command.
I'll send it to you guys tomorrow.

 

Can I get a picture of that to?

NjoyinXtremes@aol.com or
UsiRkeVa@aol.com

 

Ok, think that's everyone. If anyone else needs that pic, let me know.

 

Thanks

 

BigEvil can you send me that pic too.