Wiring/Testing a relay
04-22-2008, 05:51 PM
#1
Banned
Thread Starter
Join Date: Oct 2006
Location: Goochland, Va.
Posts: 4,974
Wiring/Testing a relay
I have a relay with 5 wires for my fuel pump. Its the fuel pump relay that come with the DFI. I have it hooked to a switch on the power side going to the pump so I can cut the pump off...but the relay will still be powered.
Will this burn up the relay?
How is it wired and how would I test one? I searching for how to test it and had no luck for the most part. But I think it is bad I swapped relays and it works fine. But want to know how to check these for future ref.
Numbers on the top
Omron
25553347
Z-7365
Side
a3129
has 30 87 87a 85 and 86 on the diagram....
Will this burn up the relay?
How is it wired and how would I test one? I searching for how to test it and had no luck for the most part. But I think it is bad I swapped relays and it works fine. But want to know how to check these for future ref.
Numbers on the top
Omron
25553347
Z-7365
Side
a3129
has 30 87 87a 85 and 86 on the diagram....
Thread
Thread Starter
Forum
Replies
Last Post
Aaront810
General 1967-2002 F-Body Tech
13
08-29-2020 09:34 PM
OutlawPerforman
Car Audio and Electronics
4
10-30-2017 05:40 PM
Ryan Ramsaran
LT1 Based Engine Tech
3
09-19-2015 08:43 PM