hello

whare can I get forged pistons so my CR will be 8-8.5:1 ?

58cc chambers
5.7 rods
3.48 strok

thanks

 

You have mail.

SRP has some -31cc dish pistons, they will give you around 8.5:1.

I run them, no complaints here.

LWM

 

thanks for the calculator

the 31cc pistons are for 3.75 strock not for 3.48

 

is that the ones for the 383 (4.030 -31cc)? how much did you pay for them? thanks.

 

Yes, those are the pistons in the 383

The reciept says C$ 1,193.74, but that was when the C$ was around .65 of the USD.

Not sure it is a relavent price.

LWM

 

I have a set for sale.. They wont put you anywhere near 8.5:1 CR on stock heads, but if you went with the Trickflow heads, these would put you right where you need to be.. They are Probe Industries pn# 12343.. They are .030 over, forged, fully floated and coated with a thermal barrier coating.. I am looking to get $400 for them.. They are brand new in the box, with all the wrist pins and spiral locks and all..

Let me know if you are interested, I need these gone so I can get my new pistons ASAP.. Everything is at the machine shop right now and I decided to go a different route with my motor (355 LE3 motor w/lots of cam) and I need my CR to be higher than 11:1 which is what these pistons put me at..

You can contact me by calling me at 310-200-5039 or e-mailing me at mleaf@bodyglove.net or mleaf@speakeasy.net or all 3.

Pics can be found at http://www.socalmuscle.com/~mleaf/engine/coatedpistons

This will be posted in the parts for sale section as well.

 

Hey SVThuh, are your pistons for 6 inch rods? If so, I got a set of SRP 11.1 . pistons .30 over. Ill trade if you want. Pm me.