I know a couple people wanted to see some hard intake pipes so I finally got around to posting some pics. There are only 3 there now but will be taking some more soon.

This is on the car in the sig. As you can tell, I had to do some custom stuff, like design and make the sc bracket, make the intake, and fab all the piping up for the front mount. Btw, I am going to move the filter to outside the engine bay via the hole just below it. Just haven't gotten around to it yet.

Here is the link: http://pg.photos.yahoo.com/ph/evolve...bum?.dir=/fb33

 

Looks pretty slick...and time consuming

 

Thanks. It took more time than it should. I learned how to weld on this project. It was more in depth than the motor/tranny swap including the wiring.

 

Well done .

Ryan

 

Looks good. You have so many welds I thought you had some corregated stuff on the blower.

 

I had to do that to tighten the radius so that I could fit it in the space provided. I made it as wide as I could but you gotta do what you have to. Plus, I wanted it to fit under the stock hood. The welds didn't go to the inside and it is suprisingly smooth inside.

 

lol we all know about trying to fit stuff in the space provided....damn 4th gen f-body engine bays...nice work =)

 

I am assuming you didn't look at the pics That is a LT1 but it is in a 3rd gen!

 

well ill be.....more room then the 4th gens....but still lacking unlike those chevelle engine bays....even with 454's in some lol