tranny-mounted torque arm-Anyone Broke the mount?
Thread Starter
Registered User
Joined: Jul 2003
Posts: 409
From: Plainfield IL.
tranny-mounted torque arm-Anyone Broke the mount?
Has anyone with an A4 (or anyone hear of someone) break the transmission mount of the Torque Arm? I have a BMR (adjustable) with the rear trans mount location. Car currently runs low-mid 12's, future goals are 11's at best. What chance does it have of breaking? Should I upgrade to a Spohn that changing the location to the g-load brace location.
FYI I had a Spohn before and sold it because it was sooooooo noisey.
FYI I had a Spohn before and sold it because it was sooooooo noisey.
Registered User
Joined: Jul 2000
Posts: 332
From: Joliet, IL
Re: tranny-mounted torque arm-Anyone Broke the mount?
Well, I think I sold you the Spohn last summer?? Can't remember for sure off MFBA borad right??
Well, the noise is bad in the car I don't think you need to worry about the trans mount until you get into the 10.50 range. I have seen them break at the track but not often. It's more a piece of mind and I would go with BMR Xtreme over Spohn IMO.
Later
Chris
Well, the noise is bad in the car I don't think you need to worry about the trans mount until you get into the 10.50 range. I have seen them break at the track but not often. It's more a piece of mind and I would go with BMR Xtreme over Spohn IMO.
Later
Chris
Thread
Thread Starter
Forum
Replies
Last Post
BLK1997Z28
Suspension, Chassis, and Brakes
0
May 1, 2015 12:23 PM
