cause4panic

1996 4l60e programmed to shift manually
So I have been told by a good friend and tranny builder to start the burn in manual second (tuned to start in second gear) shift then roll out in third. Would it be bad if I started in second then preceded to roll out?

BB

22991

If this is a wet burnout (at the strip) this would be okey. I would just start in 1st but don't redline then go to 2nd then to 3rd and rollout, with a light throttle (if the tires bite too hard it causes a severe shock to the drivetrain). my .02c

SS SLP2

My builder said do burnouts in 2 nd, if trans shifts into 3 rd in burnout it is hard on high gear clutchpack

just me and my builder's .02', Johnny