Bent rod on master cyl

Reply Subscribe

Thread Tools

Search this Thread

Feb 19, 2008 | 05:14 PM

Firebird_fr3ak

Thread Starter

Registered User

Joined: Jun 2007

Posts: 101

From: MN

Bent rod on master cyl

Ok so i put in a new RAM clutch and go to put the clutch in, and it stays on the floor. I manually pull it back up and the pin pops out and is bent all to ****. What causes this? Just a bad MC or what?

Feb 20, 2008 | 11:29 AM

RUDEDOG

Registered User

Joined: Feb 2006

Posts: 582

From: Atlanta

Mine was bent too. Don't know what caused it. I just left it alone and it works fine. The reason I left it bent is maybe what caused it was bottoming out in the slave cylinder.

Feb 20, 2008 | 11:31 AM

RUDEDOG

Registered User

Joined: Feb 2006

Posts: 582

From: Atlanta

Maybe I should'nt have assumed you were talking about the slave cylinder since you said master.

Feb 20, 2008 | 09:39 PM

Green96Z

Registered User

Joined: Sep 2007

Posts: 1,356

From: CA, home of the smog nazi

How much pressure did you put on the pedal to get it all the way down? Either way, you're gonna need a new one. Have fun with that install, no fun at all.