I recently removed the 6 speed transmission from my '95 Z28 and do not have enough clearance to remove the top 14mm bolt of the bell housing on the driver's side. Any suggestion other than pulling the engine? Thanks.

 

Loosen the motor mount bolts and jack the front of the engine up. I know that bolt, it is a PITA.

 

that bolt is a real bitch.....

You have a swivel? I think its a 9/16" also not a 14mm, the 14 will be a little tight on it. So see if you can get a swivel or a stubby or flex head gear wrench