I'm just learning how to tune my own z28. I recently did a t56 conversion and need what to tune out out the file. Also I recently did a cam swap so my BLMs were a bit off and I smoothed them out with VEmaster...anyone use that?? To be honest I don't know too much about what I am doing but would like to learn...(don't worry I like to do background research). I wanted to make sure that using VEmaster was fine since I'm running E85. Any other info is appreciated. thanks guys, Erik

 

Look into if VE works while using a MAF. My understanding was it is the table to change when using speed density mode. Some say changing VE does has some effect while usins a MAF but nothing like changing the MAF tables.

 

yea I know the MAF is used in combination with the VE tables in a checks and balance type of manner

 

It's obvious you don't know so do some research before you post. Don't tell us you will after the fact. What a noob

Grippy

 

thanks, that was very helpful (guy w/ one post). In fact you should make sure your contributions here don't go unnnoticed...