Scanmaster LT-1 Installation
Thread Starter
Registered User
Joined: Sep 2003
Posts: 264
From: Detroit Subs
Scanmaster LT-1 Installation
My Scanmaster was unhooked yesterday and when I went to reconnect it today, I noticed that terminal "E", the one that the manual says to use, isn't used in my 12 pin DLC. My choices are: A, B, G, or M.
Which one can I use for data, B or M? I know that A is a ground and G is used for the keyless entry.
Which one can I use for data, B or M? I know that A is a ground and G is used for the keyless entry.
Thread
Thread Starter
Forum
Replies
Last Post
Sergio
LT1 Based Engine Tech
11
Jan 27, 2016 04:27 PM
