Didn't know this would work
Thread Starter
Registered User
Joined: Jun 2003
Posts: 712
From: Amarillo Texas
Didn't know this would work
I put a ODBI pcm into a 97 TA 
Car picked up 2mph at the track,
Car ran like a champ after i tuned the WOT, VE, and Misc,(EGR,EVAP,KNOCK)
PCM plugged right in, tuned it with tuner cat and a ODBII cable from AKM.
The old ODBII pcm was too rich, is was programmed for a cc306 with ported heads, which are not on the car yet. So to lean it out we just plugged in an old pcm out of a 94 auto Z. I leaned it out and the TA ran faster, not a bad quick fix
Car picked up 2mph at the track,Car ran like a champ after i tuned the WOT, VE, and Misc,(EGR,EVAP,KNOCK)
PCM plugged right in, tuned it with tuner cat and a ODBII cable from AKM.
The old ODBII pcm was too rich, is was programmed for a cc306 with ported heads, which are not on the car yet. So to lean it out we just plugged in an old pcm out of a 94 auto Z. I leaned it out and the TA ran faster, not a bad quick fix
Thread Starter
Registered User
Joined: Jun 2003
Posts: 712
From: Amarillo Texas
Re: Didn't know this would work
NO i am saying that it did work and the car picked up two mph at the track.
I turned off all knock pull, so i dont have to have a resistor.
I wouldn't recomend trying this but just FYI it does work.
I turned off all knock pull, so i dont have to have a resistor.
I wouldn't recomend trying this but just FYI it does work.
Thread
Thread Starter
Forum
Replies
Last Post
Oncomingstorm22
General 1967-2002 F-Body Tech
4
Jan 22, 2015 07:15 PM
fpete1992
General 1967-2002 F-Body Tech
1
Dec 11, 2014 03:51 PM
