I got the fast track harness and im trying to figure out what they used for the 5 volt referance for the tps sensor. I misplaced my directions for the wiring. According to fast it should be E1 on the computer but i dont have a wire hook up there and the tps works fine. Anyone know what pin out fast track performance uses for the 5 volt referance?

cant get ahold of anyone there

thanks

 

According to my Fasttrack splice-in directions it says:

"Splice DK BLU wire tagged TPS SIGNAL from F.A.S.T. PCM connector cavity B-01 into DK BLU wire at GM PCM connector C (GRAY/CLEAR) cavity 22 and insulate splice"

 

is this what it clams for the 5 volt referance?

there should be a ground
signal
and 5 volt wire

thanks for the reply

Bud if its not too much of a hastle could you scan a copy of that page or take a pic. If not its cool

 

Thats the only mention of the TPS in the directions. I spliced mine in this way and it works fine. The directions don't mention anything about cavity E-01.