Fired the old girl up today, got some work to do
Thread Starter
Registered User
Joined: Nov 2005
Posts: 368
From: Jersey
Fired the old girl up today, got some work to do
So I fired the old 67 up today. It started as soon as I touched the key with a big gorwl (=
)
Covered in dust, I couldn't resist going down the road and back (1/4 mile)
I was smiling the whole way but making a note of things that need to be adressed:
The trottle is sticking: To be safe, I am going to take it all apart and take my time reassembling it
Volts drop to 12.2 at idle, 14.4 past 1400rpm: Guess pulley is too large?
Water temps VERY slowly raise up: Pulley too large again? New edlebrock pump, flex fan, and big block aluminum rad. (since both pulleys slow, may just try droping a few sizes on crank pulley)
Door moan when opening: No idea...
Pass glass is messed up: always was but no idea how to fix
paint showing wear
)Covered in dust, I couldn't resist going down the road and back (1/4 mile)
I was smiling the whole way but making a note of things that need to be adressed:
The trottle is sticking: To be safe, I am going to take it all apart and take my time reassembling it
Volts drop to 12.2 at idle, 14.4 past 1400rpm: Guess pulley is too large?
Water temps VERY slowly raise up: Pulley too large again? New edlebrock pump, flex fan, and big block aluminum rad. (since both pulleys slow, may just try droping a few sizes on crank pulley)
Door moan when opening: No idea...
Pass glass is messed up: always was but no idea how to fix
paint showing wear
Registered User
Joined: Dec 2003
Posts: 1,457
From: Seattle, Washington
Re: Fired the old girl up today, got some work to do
Thread
Thread Starter
Forum
Replies
Last Post