98 Camaro 427ci
02-12-2010, 02:47 PM
#1
Member
Thread Starter
Join Date: Jan 2002
Location: Bay Area, CA
Posts: 1,697
98 Camaro 427ci
I'm listing the Camaro for sale. If I don%u2019t get the price I want, then I wont sell. I have the title in hand, ready to sell. Also, clear title.
Those that know me and have seen my car know that I take exceptional care of it. This isn%u2019t some quickly thrown together project either%u2026 only the best parts have been used and the car runs amazing. Its pretty much a full track car ready to run 10%u2019s, also has VERY good street manners. Also full interior, heat, and AC all work. Power everything.
Car is tuned conservatively for maximum driveability, and put down 543 rwhp and 505 rwtq on the dyno.
*NOTE: I will smog for buyer. After that its the buyer's responsibility to find someone to get it smogged again in 2 years.*
I have over $25k into actual mods on the car, not including the cost of the car.
I am in no hurry to sell, so if I don%u2019t get the price I want I will keep it.
Pretty firm on the price: $15,500
1998 Camaro Z28
Motor:
-Factory new LS3 block
-427ci, 12:1 CR, bored/stroked/balanced/blueprinted
-Forged Compstar 4.1" crank
-Forged Compstar rods
-Custom Wiseco forged pistons
-ARP studs
-TSP ported L92 heads
-L76 intake manifold (paint matched to car)
-TSP 251/259 on 111 lsa .661 lift
-Kooks 1 7/8 LTs
-Nick Williams 90mm throttle body
-42# injectors
-Walbro 255lph fuel pump with custom access panel
-3" true duals with Dr. Gas X-pipe and magnaflow mufflers
-Dual DMH low-profile e-cutouts
-Fast Toys 85mm lid
-SLP CIA duct
-ZO6 MAF
-Optima Red Top
-Abear Motorsports polished valve covers (coil packs sit inside)
Drivetrain:
-D&D built T56
-Spec 3 clutch and billet flywheel
-WS6 store short stick
-Hurst classic white 6-speed shift ball
-3.42 gears
Suspension/Braking
-BMR tubular K-member
-BMR upper and lower tubular A-arms (adjustable)
-Strano revalved Bilstiens
-BMR 1" springs
-BMR boxed subrames
-BMR adj torque arm
-BMR adj LCAs
-BMR Xtreme STB (powdercoated black)
-BMR adj PHB
-Trac Tek relocation brackets
-Wolfe 6-point roll bar with door swingouts.
-Stroud 5-point safety harnesses
-Powerstop crossdrilled rotors
-Hawk Ceramic brake pads
-Earl%u2019s Stainless Steel brake lines
-ARP 3.25%u201D lengthened wheel studs for track use (all 4 corners)
Interior
-Brand new carpet from Stock Interiors
-Raamat sound deadening throughout entire car
-Retained stock seatbelts with racing harnesses
-Rear seat delete
-Pioneer DEH-P6050
-Alpine 6 %u00BD%u201D speakers in middle panels
-Interior trim pieces professionally sanded and painted to match factory ext
-Custom TA seats, repadded, genuine leather, real suede inserts, heaters, headrest embroidery
-Brand new GM seatbelts
-Emblem Pros ashtray switch plate for cutouts and line lock
Exterior
-SLP Ultra Z Ram Air hood
-RK Sport smooth grill with mesh behind
-Halo headlights (chrome)
-Brand new clear corners
-Custom stainless 427 badges (in Z28 font) by Emblem Pros
-Stainless CAMARO inserts on rear panel by Emblem Pros
-Chrome SS 10spokes
-rear 10spokes custom widened by Weldcraft to 17x11
-custom spacers for unique offset
-275%u2019s up front, 315%u2019s out back
-Paint is swirl and scratch free
Mileage:
-Body 160k
-rear 80k
-motor 4k
-trans 2k
Pics
Those that know me and have seen my car know that I take exceptional care of it. This isn%u2019t some quickly thrown together project either%u2026 only the best parts have been used and the car runs amazing. Its pretty much a full track car ready to run 10%u2019s, also has VERY good street manners. Also full interior, heat, and AC all work. Power everything.
Car is tuned conservatively for maximum driveability, and put down 543 rwhp and 505 rwtq on the dyno.
*NOTE: I will smog for buyer. After that its the buyer's responsibility to find someone to get it smogged again in 2 years.*
I have over $25k into actual mods on the car, not including the cost of the car.
I am in no hurry to sell, so if I don%u2019t get the price I want I will keep it.
Pretty firm on the price: $15,500
1998 Camaro Z28
Motor:
-Factory new LS3 block
-427ci, 12:1 CR, bored/stroked/balanced/blueprinted
-Forged Compstar 4.1" crank
-Forged Compstar rods
-Custom Wiseco forged pistons
-ARP studs
-TSP ported L92 heads
-L76 intake manifold (paint matched to car)
-TSP 251/259 on 111 lsa .661 lift
-Kooks 1 7/8 LTs
-Nick Williams 90mm throttle body
-42# injectors
-Walbro 255lph fuel pump with custom access panel
-3" true duals with Dr. Gas X-pipe and magnaflow mufflers
-Dual DMH low-profile e-cutouts
-Fast Toys 85mm lid
-SLP CIA duct
-ZO6 MAF
-Optima Red Top
-Abear Motorsports polished valve covers (coil packs sit inside)
Drivetrain:
-D&D built T56
-Spec 3 clutch and billet flywheel
-WS6 store short stick
-Hurst classic white 6-speed shift ball
-3.42 gears
Suspension/Braking
-BMR tubular K-member
-BMR upper and lower tubular A-arms (adjustable)
-Strano revalved Bilstiens
-BMR 1" springs
-BMR boxed subrames
-BMR adj torque arm
-BMR adj LCAs
-BMR Xtreme STB (powdercoated black)
-BMR adj PHB
-Trac Tek relocation brackets
-Wolfe 6-point roll bar with door swingouts.
-Stroud 5-point safety harnesses
-Powerstop crossdrilled rotors
-Hawk Ceramic brake pads
-Earl%u2019s Stainless Steel brake lines
-ARP 3.25%u201D lengthened wheel studs for track use (all 4 corners)
Interior
-Brand new carpet from Stock Interiors
-Raamat sound deadening throughout entire car
-Retained stock seatbelts with racing harnesses
-Rear seat delete
-Pioneer DEH-P6050
-Alpine 6 %u00BD%u201D speakers in middle panels
-Interior trim pieces professionally sanded and painted to match factory ext
-Custom TA seats, repadded, genuine leather, real suede inserts, heaters, headrest embroidery
-Brand new GM seatbelts
-Emblem Pros ashtray switch plate for cutouts and line lock
Exterior
-SLP Ultra Z Ram Air hood
-RK Sport smooth grill with mesh behind
-Halo headlights (chrome)
-Brand new clear corners
-Custom stainless 427 badges (in Z28 font) by Emblem Pros
-Stainless CAMARO inserts on rear panel by Emblem Pros
-Chrome SS 10spokes
-rear 10spokes custom widened by Weldcraft to 17x11
-custom spacers for unique offset
-275%u2019s up front, 315%u2019s out back
-Paint is swirl and scratch free
Mileage:
-Body 160k
-rear 80k
-motor 4k
-trans 2k
Pics
Last edited by GoFast908Z; 02-04-2011 at 03:37 PM.
03-12-2010, 08:30 PM
#5
Member
Thread Starter
Join Date: Jan 2002
Location: Bay Area, CA
Posts: 1,697
