Just getting my feelers out there right now, may not even sell!

IF I do sell, the car and engine will go as a package, no part-outs. This is a GREAT project, car would run 11s EASY on this setup but I am starting to think 5th gen?

Heres what MAY be up for sale...

1997 TA M6 (original engine needs work)
-Black
-Optioned Out!
-C6 Vette Rims
-Eibach Pro-Kit
-QA1 Coil Overs
-New Opti
-Vented/Drilled Rotors
-Ram-Air hood
-Extras

This engine has ZERO miles on it, it is as clean as they come.
396 fully forged (not splayed, no block filler)
-94 LT1 Block, bored and stroked.
-Compstar crank-4340
-Eagle I beam rods...or are they H? Argh, I will update that later.
-Negative 5cc Flat top pistons, great for boost!
-236/246 Comp XE grind
-TrickFlow heads
-Everything is there, intake to oilpan, opti and accessories need to be used from 97 engine.

I would LIKE to get somewhere around 9000 for this stuff.

T-56 Swap!

No, I will not part this out either!

Ok, this is a sweet set-up, gotta pay some people!

T-56
Pedals
Floor-Cut (Out of 4th Gen T-56 car)
Lower Boot
Center Console (with shifter plate)
Upper Boot (leather)
Computer (T-56)
Wire Harness (T-56)
Clutch
Pressure Plate
Clutch Fork
I think I have a crossmember sitting around too!

I would like to get 2000 for this stuff, but come on. Make me an offer.

Send me PMs, I am located in Gulfport, MS.