Verz

I read through the rules and said nothing against feeler threads so here we go.

I will add pics later this evening but for now majority of pics are located on my cardomain page linked in my sig
PM or email at arizzo_22@hotmail.com

Car is a 1996 Formula 6spd hardtop car. Manual windows, aftermarket keyless entry/alarm system, cloth seating with about 85k on it. Motor is currently on a stand waiting to be dropped in and trans is sitting aside aswell. Reason for selling i found a car ive been looking for since before I bought this in 2008 and i cant pass it up. Motor was being built up to make some pretty good power

Motor is a stock shortblock with 80k on it but has been gone through to make sure all bearings, rods/crank and bolts are good and has been stuffed full of brand new performance goodies. Heads had been pulled and cleaned. Comes with all acc minus ac but comes with ac delete pulley, motor is complete minus a few bolts here and there but those can be included.
Motor mods
Custom Llyod Elliot grind: specs 22x/23x .56x/.56x 10x LSA-150miles on it
patriot gold valvespring kit-new
ls7 lifters-new
Trickflow factory length pushrods-new
1.6 pro mags nsa rockers, comp 7/16 studs and guide plates-all new
pro gear single roller timing set-new
MSD opti(new) and coil(10k on it) and ac delco with 20k on it
meizere ewp-new

Trans is stock but a Ram Powergrip hd clutch and factory flywheel is also included. Needs a 3rd gear shift fork.

Lpp stainless longtubes and ory are brand new, never installed and also have an exhaust which consists of borla piping with all the plates, an aeroturbine 3030 stainless muffler and corsa dual stainless tips.

Car has the following suspension mods-
Z06 wheels 18x9 and 18x9.5
QA1 Coilovers-front
QA1 Adjustable Shocks-rear
Eibach Sportline Springs-Rear
SLP Lower Control Arms
SLP front and Rear sway bars
Tubular K-member with tubular upper and lower a arms
Tubular Panhard bar.
Baer 13.5" eradi speed rotors and calipers

Car does have some body damage, front bumper paint is peeling off, fist sized dent in driver side quarter and paint chipping above passenger rear wheel. Tires will need replaced and one wheel is bent and cracked but have 2 chrome z06 wheels for replacements to go with car. Now has honeycomb tails on it.

Asking $4500 for everything, all you need to get it going; again minus a few bolts and stereo but who needs that with an exhaust setup like that.

If I part would like to get
Roller with full interior-$1700
Motor and trans-$2000
Headers-$550
Exhaust, whole setup without piping to attach tips-$450 but willing to seperate

I will add pics later this evening but for now majority of pics are located on my cardomain page linked in my sig




TB pictured is not included







Thanks Aaron

PM or email at arizzo_22@hotmail.com